Connector-Terminal Block Conversion Unit
By using the Connector-Terminal Block Conversion Unit in combination with a Connector Terminal
Block Cable (XW2Z-@J-B28), the Servo Drive's Control I/O Connector (CN1) can be converted to
a terminal block.
XW2B-34G4 (M3 screw terminal block)
Dimensions
3.5
Precautions
for Correct Use
Flat cable connector (MIL plug)
112.5
5.08
Terminal block
Use 0.30 to 1.25 mm
The wire slot is 1.8 mm (height) × 2.5 mm (width).
Strip the insulation from the end of the wire for 6 mm as shown below.
6 mm
3-4 Cable and Connector Specifications
3.5
Two,
3.5 dia.
2
wire (AWG22 to AWG16).
3
3-48