Power-Up; Line Power Connection; Figure 2-3 Power Module - Keithley 2010 User Manual

2-8 Basic Measurements

Power-up

Line power connection

Follow the procedure below to connect the Model 2010 to line power and turn on the
instrument.
1.
CAUTION
2.
3.
WARNING
4.
Figure 2-3
Power module
350V
PEAK
!
Check to be sure the line voltage selected on the rear panel (see
the operating voltage in your area. If not, refer to the next procedure, "Setting line
voltage and replacing fuse."
Operating the instrument on an incorrect line voltage may cause damage to
the instrument, possibly voiding the warranty.
Before plugging in the power cord, make sure the front panel power switch is in the off
(0) position.
Connect the female end of the supplied power cord to the AC receptacle on the rear
panel. Connect the other end of the power cord to a grounded AC outlet.
The power cord supplied with the Model 2010 contains a separate ground
wire for use with grounded outlets. When proper connections are made,
instrument chassis is connected to power line ground through the ground
wire in the power cord. Failure to use a grounded outlet may result in
personal injury or death due to electric shock.
Turn on the instrument by pressing the front panel power switch to the on (1) position.
Model 2010
WARNING: WARNING:
NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
HI
MADE IN
U.S.A.
1000V
TRIGGER
PEAK
!
LINK
RS232
!
LO
500V
1 3 5 VMC
SENSE INPUT PEAK
2 4 6 EXT TRIG
Ω 4W
!
FUSE LINE
250mAT 100 VAC
(SB) 120 VAC
125mAT 220 VAC
(SB) 240 VAC
CAUTION: CAUTION:
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING. FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING.
IEEE-488
(CHANGE IEEE ADDRESS
FROM FRONT PANEL)
LINE RATING
50, 60
400HZ
17 VA MAX
Line Voltage Selector
Fuse
Spring
Fuse Holder Assembly
Figure 2-3) is correct for
Window