Scan Commands - Keithley 2010 User Manual

:OPEN <list>
:ROUTe:MULTiple:OPEN <list>
Parameter
Description

:SCAN commands

[:INTernal] <list>
:ROUTe:SCAN[:INTernal] <list>
Parameter
Query
Description
NOTE You can only scan consecutive channels. Skipping channels is not allowed. For
example:
(@1:4) is valid.
(@1,2,4) is not valid.
<list> = (@ chanlist)
where chanlist is the list of channels (1 through 11) to be opened.
This command is used to open specified channels on the internal scanner
card. When this command is sent, the channels specified in the chanlist will
open.
Channel 11 is the 2-pole/4-pole relay. Opening channel 11 selects the 4-pole
operating mode.
Examples of a list:
list = (@1,3,5) Channels 1, 3, and 5.
= (@1:5) Channels 1 through 5.
<list> = (@ scanlist)
where scanlist is the specified list of channels (1 through 10) to be scanned.
[:INTernal]?
This command is used to define the scan list for the internal scanner card. The
scan list can contain two to ten channels. The following examples
demonstrate the various forms for expressing a scan list:
list = (@ 2,3,4) Channels separated by commas (,).
(@ 1:8) Range of channels (1 through 8). Range limits separated
by a colon (:).
See the instruction manual of the internal scanner card for details on scanning.
SCPI Command Reference
Open specified channels
Specify channels to open
Define internal scan list and enable scan.
Query programmed scan list
5-35