Telnet Client Support; Introduction To Telnet; Telnet Commands - Avaya C360 Installation And Configuration Manual

Telnet Client Support

Introduction to Telnet

The C360 supports invocation of a Telnet client from the CLI. The Telnet client implementation
enables you to control the destination port for connecting daemons that listen on a non-default
port.
Authentication when connecting to the switch via Telnet is identical to standard console
connection authentication (local or RADIUS).
Tip:
Enabling and disabling the Telnet-client service can only be done using a direct
Tip:
console connection via the Console port.
By default the Telnet-client service is disabled.

Telnet Commands

The following Telnet commands are available.
In order to...
Open a Telnet session to
another device.
Enable Telnet access from the
switch
Disable Telnet access from the
switch
For a complete description of the Telnet CLI commands, including syntax and output examples,
refer to the Reference Guide for the Avaya C360 Converged Stackable Switch, 10-300506.
Use the following command...
telnet
ip telnet-client enable
no ip telnet-client
Telnet Client Support
Issue 1 July 2006 109