StarTech.com 16 Port StarView CAT5 UTP KVM Instruction Manual page 43

If you didn't enable Check Firmware Version, the Utility installs the
upgrade files without checking whether they are a higher level or not.
5. As the Upgrade proceeds, status messages appear in the Status
Messages panel and the progress toward completion is shown on the
Progress bar.
6. To abort the upgrade procedure before it completes, click
you cancel before completion, a dialog box appears warning you that
quitting at this point may cause the device firmware to be lost, and you
are given the option to proceed or abort the cancel operation.
Upgrade Succeeded
After the upgrade has completed, a screen appears to inform you that the
procedure was successful. Click Finish to close the Firmware Upgrade
Utility.
Upgrade Failed
If the upgrade failed to complete successfully a dialog box appears asking
if you want to retry. Click Yes to retry. If you Click No, the Upgrade Failed
screen appears. Click Cancel to close the Firmware Upgrade Utility. See
the next section, entitled Firmware Upgrade Recovery, for directions on
how to proceed.
Firmware Upgrade Recovery
The following situations require firmware upgrade recovery:
• When the unit's firmware becomes corrupted for some reason,
rendering inoperable
• When you invoke Firmware Upgrade Mode, but decide not to proceed
with the upgrade
• When a firmware upgrade procedure is interrupted or fails
Instruction Manual
36
Cancel. If