Table of Contents
Advertisement
input. Pressing [Esc] exits Hotkey Mode.
Selecting the Active Port
Each Computer Port is assigned a Port ID. You can directly access any
computer on the installation with a Hotkey combination that specifies the
Port ID of the Computer Port that the computer is connected to. The steps
involved are:
1.
Invoke Hotkey Mode.
2.
Key in the Port ID. The Port ID numbers display on the Command Line
as you key them in. If you make a mistake, use [Backspace] to erase
the wrong number.
[Enter]. The KVM focus switches to the designated computer
3.
Press
and you automatically exit Hotkey Mode.
Auto Scanning
Auto Scan automatically switches among all the active Computer Ports
that are accessible to the currently logged on User at regular intervals, so
that activity can be automatically monitored.
Setting the Scan Interval
The amount of time Auto Scan dwells on each port is set with the SCAN
DURATION setting of the OSD F3 SET function. You can change the scan
interval before activating Hotkey Auto Scanning, if you wish, with the fol-
lowing Hotkey combination:
1.
Invoke Hotkey Mode.
[T] [n] Where [T] is the letter T, and [n] is a number from 1-255
2.
Key in
that represents the number of seconds for the dwell time. (The letter T
and the numbers display on the Command Line as you key them in. If
you make a mistake, use [Backspace] to erase the wrong number.)
[Enter]. After you press [Enter], you automatically exit Hotkey
3.
Press
Mode, and are ready to invoke Auto Scanning.
Instruction Manual
28
Advertisement
Table of Contents
Need help?
Do you have a question about the 16 Port StarView CAT5 UTP KVM and is the answer not in the manual?