StarTech.com 16 Port StarView CAT5 UTP KVM Instruction Manual page 33

Auto Scan Mode.
• If the scanning stops on an empty port, or one where the computer
is attached but is powered Off, the monitor screen will be blank, and
the mouse and keyboard will have no effect. Simply wait - after the
Scan Duration time is up, the Scan function will move on to the next
port.
• As each computer is accessed, an
display to indicate that it is being accessed under Auto Scan Mode.
• While Auto Scan Mode is in effect, the console will not function
normally. You must exit Auto Scan Mode in order to regain control of
the console.
• While you are in Auto Scan Mode, you can pause the scanning in order
to keep the focus on a particular computer by pressing P
• To exit Auto Scan Mode, press
F8 LOUT
Pressing [F8] logs you out of OSD control of the computers, and blanks
the Console screen. This is different from simply pressing [Esc] when you
are at the Main Screen to deactivate the OSD. With this function you must
log in all over again to regain access to the OSD, whereas with [Esc], all
you have to do to re-enter the OSD is tap the OSD Hotkey.
Please Note:
1. When you reenter the OSD after logging out, the screen stays blank
except for the OSD Main Screen. You must input your password before
you can continue.
2. If you re-enter the OSD after logging out, and immediately use [Esc]
to deactivate the OSD without having selected a port from the OSD
menu, a Null Port message displays on the screen. The OSD Hotkey
will bring up the Main OSD Screen.
Instruction Manual
S appears in front of the Port ID
[Spacebar] or [Esc]
26