Powering Off And Restarting - StarTech.com 16 Port StarView CAT5 UTP KVM Instruction Manual

and plugging into a new one. Following this, in order for the OSD menus
to accordingly reflect the change, you must reset the OSD. See RESET
STATION IDS, page 24, for details.
Hot Plugging KVM Ports
After switching KVM ports, in order for the OSD menus to accurately
reflect the change, you must manually reconfigure the OSD information
for the new Port information. See F3 SET, page 19, and the Port Setting
selections under the F4 ADM function, page 21, for details.
Please Note: If the computer's Operating System doesn't support hot
plugging, this function may not work properly.
Hot Plugging Console Ports
Keyboard, monitor, and mouse can all be hot plugged. When hot plugging
the mouse:
• You may unplug the mouse and plug it back in again (to reset the
mouse, for example), as long as you use the same mouse.
• If you plug in a different mouse, all the stations and all the computers
on the installation must be shut down for 10 seconds, then restarted
following the Power Up Sequence described on page 9.)
Please Note: If, after hot plugging (or at any other time), there is no
response to keyboard and/or mouse input, perform a Keyboard and
Mouse Reset by pressing in the Reset switch (see #3, page 3).

Powering Off and Restarting

If it becomes necessary to power off the switch, or if the switch loses
power and needs to be restarted, before re-starting you must follow these
procedures:
1. Shut down all the computers that are attached to the switch.
must unplug the power cords of any computers that have the Keyboard
Power On function.
2. Wait 10 seconds then power the switch back on. If you have shut down
Instruction Manual
14
Note: You