Adjusting The Amount Of Slack In The Paper - Kyocera KM-1820 Service Manual

(3) Adjusting the amount of slack in the paper

Make the following adjustment if the leading edge of the copy image is missing or varies randomly, or if the copy paper is
Z-folded.
Procedure
Enter maintenance mode.
Enter 051 using
up/down cursor keys.
Press the enter key.
Select the item to be adjusted
using up/down cursor keys.
Regist. Cas.1: Drawer
Regist. MPT: MP tray
Regist. Cas.2: Optional drawer
Press the system menu/counter key.
Press the start key
to output a test pattern.
(Printing cannot be stopped until the
preset number of sheets is printed.)
Is the leading
edge missing or
varying randomly (copy
example 1)?
Is the copy
paper Z-folded (copy
example 2)?
Press the back key to
exit maintenance mode.
Start
Yes
No
Yes
No
End
Correct image
Press the enter key.
The new setting is stored.
Press the system menu/counter key.
Increase the value using the right cursor key.
Press the system menu/counter key.
Decrease the value using the left cursor key.
Setting range: –50 to +50
Initial setting: 0
Changing the value by 1 changes
the amount of slack by 0.18 mm.
The greater the value,
the larger the amount of slack;
the smaller the value, the smaller
the amount of slack.
Copy Copy
example 1 example 2
Figure 1-6-54
2GM
1-6-43