Maintenance Mode; Executing A Maintenance Item - Kyocera KM-1820 Service Manual

1-4-1 Maintenance mode

The machine is equipped with a maintenance function which can be used to maintain and service the machine.

(1) Executing a maintenance item

* The test print mode cannot be stopped until the preset number of sheets is printed. To stop the operation, remove the
cassette to cause a paper empty state. To terminate the test print mode in the middle of operation, you must turn off the
power switch and then on again to exit the maintenance mode.
Start
Press the system menu/counter key.
Select Service setting using
the up/down cursor keys.
While pressing the start key and the # key,
press the enter key.
Select Maintenance mode using
the up/down cursor keys.
Press the enter key.
Enter the maintenance item
number using the up/down keys.
Press the enter key.
The selected maintenance item is run.
Press the back key.
Yes
Repeat the same
maintenance item?
Yes
Run another maintenance
item?
Turning power switch off and back on
End
No
No
Maintenance mode is entered.
The maintenance item is
selected.
Maintenance mode is exited.
2GM
1-4-1