Adjusting The Margins For Scanning The Original From The Dp - Kyocera KM-1820 Service Manual

(13) Adjusting the margins for scanning the original from the DP

Perform the following adjustment if margins are not correct.
U403
U404
(P. 1-6-48)
Caution:
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
Procedure
Enter maintenance mode.
Enter 404 using
up/down cursor keys.
Press the enter key.
Select the item to be adjusted
using up/down cursor keys.
A Margin: DP left margin
B Margin: DP leading edge margin
C Margin: DP right margin
D Margin: DP trailing edge margin
Press the system menu/counter key.
Place an original on the DP and press
the start key to make a test copy.
(Printing cannot be stopped until the
preset number of sheets is printed.)
Are the margins correct?
Yes
Proceed to another mode?
Press the back key
to exit maintenance mode.
Start
Ejection direction
No
Yes
No
End
(reference)
DP left margin
(3 ± 2.5 mm)
Press the enter key.
The new setting is stored.
Press the system menu/counter key.
Increasing the value using the right
cursor key makes the margin wider.
Decreasing the value using the left
cursor key makes the margin
narrower.
Setting range (change in value per step)
DP left margin: 0.0 to +10.0 (0.5 mm)
DP leading edge margin: 0.0 to +10.0 (0.5 mm)
DP right margin: 0.0 to +10.0 (0.5 mm)
DP trailing edge margin: 0.0 to +10.0 (0.5 mm)
DP leading edge margin
DP trailing edge margin
(3 ± 2.5 mm)
Figure 1-6-64
2GM
(3 ± 2.5 mm)
DP right margin
(3 ± 2.5 mm)
1-6-53