Removing The Heat Roller - Kyocera KM-1820 Service Manual

2GM

(3) Removing the heat roller

WARNING
• The heat roller is extremely hot immediately after the machine was running. Allow substantial period of time until it cools
down.
1. Remove and split the fuser unit (see page 1-6-18).
2. Remove the heater lamp (see page 1-6-22).
3. Press the lamp A holder away from the heat roller. Pull up both heat R bush and heat L bush at the same time.
Lamp A
holder
1-6-22
Heat R bush
Figure 1-6-25 Removing the heat R bush and heat L bush
Heat L bush