Removing The Main Charger Unit - Kyocera KM-1820 Service Manual

2GM

1-6-16 Removing the main charger unit

1. Remove the process unit from the machine (see page 1-6-2).
2. Unlatch three snaps, and remove the main charger cap.
3. Draw the main charger unit in the direction of arrow A, then pull it out in the direction of arrow B.
Main charger
unit
CAUTION
• When refitting the main charger unit, hold terminal down C, then push frontwards. Use care not to deform the terminal.
1-6-40
B
C
Terminal
Main charger
unit
Figure 1-6-51 Removing the main charger unit
A
Snaps
Main charger
Snap
cap