Adjusting The Dp Leading Edge Registration - Kyocera KM-1820 Service Manual

2GM

(10) Adjusting the DP leading edge registration

Perform the following adjustment if there is a regular error between the leading edge of the original and the copy image.
U034 U066
(P. 1-6-41) (P. 1-6-46)
Caution:
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
Procedure
Enter maintenance mode.
Select Lead Edge Adj.
(DP leading edge registration)
using up/down cursor keys.
Press the system menu/conter key.
Place an original on the
DP and make a test copy.
(Printing cannot be stopped until the
preset number of sheets is printed.)
to exit maintenance mode.
1-6-50
U071
Start
Enter 071 using
up/down cursor keys.
Press the enter key.
Is the image correct?
Yes
Press the back key
End
Leading edge registration
Original
Press the enter key.
The new setting is stored.
Press the system menu/conter key.
For copy example 1, decrease
No
the value using left cursor key.
For copy example 2, increase the
value using the right cursor key.
Setting range: -32 to +32
Initial setting: 11
Changing the value by 1 moves
the copy image by 0.293 mm.
Copy Copy
example 1 example 2
Figure 1-6-61