Adjusting The Dp Trailing Edge Registration - Kyocera KM-1820 Service Manual

(11) Adjusting the DP trailing edge registration

Perform the following adjustment if the original scanning end position is not correct when the DP is used.
Caution:
If the copy image looks like copy example 2, clean the DP original scanning section.
Procedure
Enter maintenance mode.
up/down cursor keys.
Press the enter key.
Select Trail Edge Adj.
(DP trailing edge registration)
using up/down cursor keys.
Press the system menu/counter key.
Place an original on the DP
and make a test copy.
(Printing cannot be stopped until the
preset number of sheets is printed.)
Is the image correct?
Press the back key
to exit maintenance mode..
Start
Enter 071 using
Yes
End
Original
Press the enter key.
The new setting is stored.
Press the system menu/counter key.
For copy example 1, decrease the
No
value using the left cursor key.
For copy example 2, increase the
value using the right cursor key.
Setting range: –42 to +32
Initial setting: 0
Changing the value by 1 moves
the copy image by 0.293 mm.
Copy Copy
example 1 example 2
Figure 1-6-62
2GM
1-6-51