Installing A Pci Card - HP xw4600 Service And Technical Reference Manual

2. Open the PCI card retention clamp. Press the retention clamp levers down to unsnap, and then
rotate them up (1).
Figure 4-30
3. Lift the PCI card out of the chassis (2). Store the card in an anti static bag.
4. Install a PCI slot cover and close the PCI retention clamp. If the PCI retention clamp levers do not
close, ensure that all cards are properly seated, and then try again.

Installing a PCI card

To install a PCI card:
1. Disconnect power from the system
access panel
bracket, if installed
84 Chapter 4 Removal and replacement procedures
Removing a PCI card
(Predisassembly procedures on page
(Removing the side access panel on page
(PCI card support bracket on page
58), remove the side
64), and then remove the PCI card support
80).
ENWW