5.
Attach the data (1) and power (2) cables to the SATA drive.
Figure 4-54
6.
For a single SATA drive, connect the SATA 0 data cable from the hard drive (1) to the SATA0 port
(2) in the workstation chassis.
For a second SATA drive, connect the SATA 1 data cable from the hard drive to the SATA1 port
in the workstation chassis.
Figure 4-55
NOTE:
To install three or four SATA drives, install the third and fourth drives in the workstation optical
bays. See
Installing SATA hard drives in the optical drive bays (optional) on page 102
ENWW
Connecting the SATA cables to the SATA drive
Connecting the SATA data cable to the workstation SATA port
Removing and replacing components 101
for instructions.