System Speaker - HP xw4600 Service And Technical Reference Manual

2. Disconnect the power button assembly cable from the system board.
Figure 4-16
3. Press in on the clips that secure the power button assembly to the chassis (1).
Figure 4-17
4. Dislodge the metal clip from the chassis by rocking the power button assembly back and forth, and
then slide the power button assembly out from the front of the chassis (2).
NOTE: To replace the power button assembly, reverse the previous steps.

System speaker

This section describes how to remove the system speaker.
72 Chapter 4 Removal and replacement procedures
Removing the power button assembly cable
Removing the power button assembly
ENWW