Pci Card; Removing A Pci Card - HP xw4600 Service And Technical Reference Manual

2. Open the PCI card retention clamp. Press the retention clamp levers down to unsnap, and then
rotate them up (1).
Figure 4-29
3. Remove the PCI slot cover (2).
4. Align the keyed components of the PCI card with the slot , and then firmly seat the card in the slot
(3).
5. Close the PCI card retention clamp by rotating the clamp downward and pressing the two green
clamp levers from the rear panel of the chassis (4).

PCI card

This section describes removing and installing PCI cards.

Removing a PCI card

To remove a PCI card:
1. Disconnect power from the system
access panel
bracket, if installed
ENWW
Installing a PCI Express card
(Predisassembly procedures on page
(Removing the side access panel on page
(PCI card support bracket on page
58), remove the side
64), and then remove the PCI card support
80).
Removing and replacing components 83