Installing A Sata Hard Drive - HP xw4600 Service And Technical Reference Manual

3. Lift the green drive-lock release tab (1) and slide the hard drive out of the chassis (2).
Figure 4-53
4. Remove the four guide screws from the hard drive and retain them for later use.

Installing a SATA hard drive

To install one or two SATA hard drives:
1. Disconnect power from the system
the side access panel
2. Select a drive bay in which to install the SATA hard drive.
3. Install the four silver, ANSI 6–32 guide screws into the hard drive.
4. Slide the SATA drive into the selected bay until it snaps into place.
100 Chapter 4 Removal and replacement procedures
Removing the SATA hard drive
(Predisassembly procedures on page
(Removing the side access panel on page
58), and then remove
64).
ENWW