Adjuster Installation And Adjustment; Using The Transport Handle - Sharp AR-M355U Service Manual

<Other than English area in Europe>
AR-M351U/
M451U
❍
Key Sheet
(PRINT display)
✕
Key Sheet
(DOCUMENT
FILING display)

14. Adjuster installation and adjustment

1) Insert the left adjuster into the paper feed desk.
2) Turn each adjuster until it is brought into contact with the floor.
2
2
1
Be sure to install the left adjuster in order to prevent falling down
of the machine.
Note: If the adjusters are not lowered to the specified positions,
the lower stage tray cannot be pulled out.
AR-M351U/M451U, AR-M355U/M455U UNPACKING AND INSTALLATION 6 - 14
AR-M351U/ AR-M351U/
M451U + M451U +
AR-NC7 AR-NC8
❍ ✕
✕ ❍
Reference
Reference
2
2

15. Using the transport handle

1) Remove the screw, and remove the handle.
2) Insert the handle into the left rack notch diagonally upward as
shown in the figure.
3) Attach the screw which was removed in procedure 1) to
secure the handle.
A
4) Lift the rear edge of the handle to engage the head with
the rack.
5) After completion of transport, restore the handle to the original
position.
A