Ar-M351U/M451U (Europe)); A. Ar-D28 - Sharp AR-M355U Service Manual

3) Remove the cushioning materials from the right and left of the
front side.
4) Remove the locking tape from the right and left sidesof the
tray.
Then, Remove the top of the carton and lower the plastic bag
covering the machine while the machine is still on the carton
base.
5) Remove the packing tape from the paper tray, pull out the
paper tray until it stops and remove it by tilting it upward.
6) One person must lift by the empty front tray pocket with the
right hand and steady the machine with the left hand placed at
the upper left of the machine.
The other person must lift with the right hand by using the lift-
ing recess in the rear of the machine and also steady the
machine with the left hand as shown in the illustration.
Note: The center of gravity of the machine lies in the left side
when viewed from the Back of machine. When lifting the
machine, be careful not to drop it.
AR-M351U/M451U, AR-M355U/M455U UNPACKING AND INSTALLATION 6 - 3
4. Remove the locking tape
5. Unpacking and installation of the
Note: In advance to installation of the machine, the paper feed

A. AR-D28

<Before installation>
• Start installation after checking that the DATA and COMMUNI-
CATION indicators on the operation panel are neither lit nor
blinking.
Front side
Rear side
<Parts included>
(AR-M355U/M455U (North America),

AR-M351U/M451U (Europe))

desk unit
option units (AR-D27/AR-D28/AR-MU2) should have been
installed.
Front mounting
plates: 2 pcs.
Left adjuster: 1 pc.
Left paper guides: 2 pcs.
Rear mounting Screws (M4x6):
4 pcs.
plates: 2 pcs.
Right paper guides: 2 pcs.