Sharp AR-M355U Service Manual page 161

24-4
Purpose Data clear
Function Used to reset the maintenance counter.
(Purpose)
Item Counter
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
4) Press [START] key.
1 MAINTENANCE Maintenance counter
SIMULATION 24-4
MAINTENANCE COUNTER DATA CLEAR. PRESS START.
1. MAINTENANCE
Press [START] key. Press [CUSTOM SETTINGS] key or [START] key.
SIMULATION 24-4
* COUNTER DATA CLEAR.
ARE YOU SURE?
1. YES
2. NO
* = MAINTENANCE
24-5
Purpose Data clear
Function Used to reset the developer counter. (The
(Purpose) developer counter of the DV unit which is installed
is reset.)
Section Image process (Photoconductor/Developing/
Transfer/Cleaning)
Item Counter
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
4) Press [START] key.
1 DV CARTRIDGE Developer cartridge
SIMULATION 24-5
DEVELOPER COUNTER DATA CLEAR. PRESS START.
1. DV CARTRIDGE
Press [START] key. Press [CUSTOM SETTINGS] key or [START] key.
SIMULATION 24-5
* COUNTER DATA CLEAR.
ARE YOU SURE?
1. YES
2. NO
* = DV CARTRIDGE
1
1
Developer
1
1
AR-M351U/M451U, AR-M355U/M455U SIMULATION 9 - 25
24-6
Purpose Data clear
Function Used to reset the copy counter.
(Purpose)
Item Counter
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
4) Press [START] key.
1 COPY Copy effective paper counter
SIMULATION 24-6
COPY COUNTER DATA CLEAR. PRESS START.
1. COPY
Press [START] key. Press [CUSTOM SETTINGS] key or [START] key.
SIMULATION 24-6
* COUNTER DATA CLEAR.
ARE YOU SURE?
1. YES
2. NO
* = COPY
24-7
Purpose Data clear
Function Used to clear the OPC drum counter. (Perform this
(Purpose) simulation when the OPC drum is replaced.)
Section Image process (Photoconductor/Developing/
Transfer/Cleaning)
Item Counter
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
4) Press [START] key.
After replacing the OPC drum, be sure to clear the OPC drum
counter.
1 DRUM
Copy
1
1
Photo conductor
OPC drum counter