C. Ar-Mu2 - Sharp AR-M355U Service Manual

<3> Reattach the harness cover to its original position and fix it
with the removed screw.
At this time, ensure that the power supply I/F harness is
arranged as shown in the illustration.
• Fix the harness securely to the wire saddle.
Power supply
I/F harness
Wire saddle
6) Adjust the position of the paper guides of the upper paper tray
of the stand/paper drawer.
Refer to "Setting and adjustment" described later.
7) Carry out the off center adjustment.

C. AR-MU2

<Parts included>
Front mounting plates:
Rear mounting plates:
2 pcs.
1) Turn off the main switch of the main unit of the printer.
Turn the main switch located on the front side of the main unit
to the "OFF" position.
Then, remove the power plug of the main unit from the outlet.
AR-M351U/M451U, AR-M355U/M455U UNPACKING AND INSTALLATION 6 - 7
Screw
Harness cover
Wire saddle
Screws (M4x8):
2 pcs. 4 pcs.
"OFF"
2) Put the main unit of the printer on the multi purpose drawer.
<1> Pull out the paper tray of the main unit until it stops and then
remove it by lifting both ends of the tray.
<2> Hold the main unit of the printer at the positions shown in the
illustration and put the main unit on the multi purpose drawer
so that the front side and the left side of the main unit are
aligned to those of the multi purpose drawer.
Caution: For installation of the main unit, it must be held by two
persons and installed without haste.
3) Connect the main unit of the printer to the multi purpose
drawer.
<1> Attach the rear mounting plates using a supplied screw for
each.
Rear mounting plate
Tray frame
Caution: Insert the mounting plate under the desk frame.
Front side
Rear side
Rear mounting plate
Screw
Screw
Mounting
plate