Setting The Video Gain And Lift (Utp Video Output) - Honeywell ACUIX User Manual

Setting the Video Gain and Lift (UTP Video Output)

Document 800-05662V1 Rev A
04/11
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Note If the dome is configured for IntelliBus protocol, for each motion
detect event an IntelliBus motion detect message is sent to the
IntelliBus master.
To enable/disable motion detection:
1. Select 5 Camera Options
The following message appears:
This will Disable Image Stabilization. Are you sure that you
want to do this? Y/N
2. Select Y (yes) to continue, or select N (no) to cancel.
If Y is selected, the message
You can adjust the video gain and lift settings when running video signals over
unshielded twisted pair (UTP) wiring.
The lift setting boosts the high frequency in the video to compensate for high
frequency losses over long cable distances. The greater the UTP wiring
distance, the higher the setting.
To enable/disable video gain:
• Select 7 Enhanced Features
(default).
To adjust the video lift and gain pulse width modulation (PWM) levels:
1. Enable video gain.
2. Select 7 Enhanced Features
Level 0–100.
3. Select a value between 0 and 100. Use

9 Motion Detection.
Motion Detection Enabled

1 Video Gain (UTP)

2 Lift PWM Level 0–100 or 3 Gain PWM
Table 7-2 as a reference.
appears.

ON or OFF
49