Programming A Mimic Tour; Running A Mimic Tour - Honeywell ACUIX User Manual

Programming a Mimic Tour

Running a Mimic Tour

Document 800-05662V1 Rev A
04/11
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
You can program up to 16 mimic tours at up to 120 seconds each.
Using MAXPRO-mode/VCL/VCL UTC/ Pelco P/Pelco D protocol:
1. Enter one of the following special presets on your controller:
• Preset 77 to create a mimic tour number between 1 and 16
• Preset 83 to create mimic tour 1
• Preset 84 to create mimic tour 2
• Preset 85 to create mimic tour 3
2. During the 120 second countdown, pan and tilt the dome and adjust the
lens zoom setting as required.
3. To end the programming mode, wait for the countdown to reach 0 or enter
preset 86.
Using Diamond/IntelliBus protocol:
1. Select 6 Function Programming
a Tour.
2. Enter the number of the mimic tour you want to program.
3. During the 120 second countdown, pan and tilt the dome and adjust the
lens zoom setting as required.
4. To end the programming mode, wait for the countdown to reach 0 or press
ESC (or your controller's equivalent).
Using MAXPRO-mode/VCL/VCL UTC/Pelco P/Pelco D protocol:
• Enter one of the following special presets on your controller:
• Preset 76 to run a mimic tour number between 1 and 16
• Preset 80 to run mimic tour 1
• Preset 81 to run mimic tour 2
• Preset 82 to run mimic tour 3

1 PTZ Mimic Tour Menu

2 Program
63