Installing The Scan Assembly; Figure 2-3 Acuix Scan Assembly - Honeywell ACUIX User Manual

Installing the Scan Assembly

Installing the Scan Assembly
8
To set the baud rate and parity:
• Using Table 2-4 and
SW6 to correspond to the baud rate and parity values of the protocol that
you have selected.
If any of the settings on SW5 or SW6 are invalid, the system reverts to the
factory default settings: MAXPRO-mode at 9600 baud, even parity.
After you have set the dome address, protocol, baud rate, and parity on the scan
assembly circuit board, you can install the scan assembly in the housing. The
installation procedure is the same for all housing styles (in-ceiling, pendant, or
rugged).
CAUTION
Do not remove the camera from the scan assembly.
Handle the camera lens with extreme care.
To install the scan assembly in the housing:
1. Remove the plastic lens cap and foam insert from the scan assembly.
Do not touch the lens.
2. Rotate and line up the yellow label on the scan assembly with the yellow
label on the housing.
3. Gently push the scan assembly into the housing until the two locking tabs
on the scan assembly snap into the guides on the housing.
4. Ensure that the scan assembly is attached securely inside the housing.
Figure 2-3 ACUIX Scan Assembly
Table 2-5 as a reference, position the pins on switch
Locking tab
Yellow label