System Administration and Equipment Handling
Resetting the Dome
82
To recover a lost user login PIN:
1. Enter preset 72 on your controller.
2. Write down the numbers that appear on the screen.
3. Contact Honeywell Technical Support to recover the PIN.
To change the privacy zone password (Diamond or IntelliBus™ protocol only):
1. Enter preset 75 on your controller.
2. Enter the current password.
3. Select 3 Reset Privacyzone Password. The password is reset to the
factory default password, which is blank. To enter a blank password, press
Enter at the password prompt.
Resetting the dome is the same as turning the dome off and then back on again.
It restarts the dome, preserving all of the dome setup information.
Note
After you select this menu option, there is no warning before the reset
begins.
To reset the dome:
•
Select 4 Diagnostics Options
To reset the camera lens only:
•
Enter preset 98 on your controller.
7 Scan and Dome Reset.