Setting The Startup State Restore; Setting Auto Focus - Honeywell ACUIX User Manual

Setting the Startup State Restore

Setting Auto Focus

Document 800-05662V1 Rev A
04/11
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
By default, the dome automatically "finds home" on startup. When this function
is enabled, the dome will find home on startup and then revert to the position it
was at prior to the last shutdown, as well as the function it was executing prior to
the last shutdown.
To enable/disable startup state restore:
1. Select 3 Control Options

Restore ON (default) or OFF.
2. If ON is selected, the following message appears:
Extreme Caution: This will move the dome to previous shutdown
position on startup. Are you sure that you want to do this? Y/N
Select Y (yes) to continue, or select N (no) to cancel.
Auto focus causes the lens to remain in focus when using zoom and/or pan and
tilt functions. The following auto focus settings are available:
• Z: The camera focuses automatically when the zoom setting changes.
• PTZ: The camera focuses automatically when using PTZ functions.
• OFF: The focus is operated manually using the controller.
To set auto focus:
• Select 3 Control Options
To set preset and preset tour auto focus, see
56 and Setting Preset Tour Auto Focus

4 Set Pan and Tilt Options
 
6 Auto Focus Z (default), PTZ, or OFF.
Setting Preset Auto Focus
on page 60.

7 Startup State
.
on page
27