Vipersat Migration; Figure 3-59 Vipersat Migration Prompt - Comtech EF Data Vipersat CDD-562L User Manual

V i p e r s a t C o n f i g u r a t io n
the VMS in an N:M redundancy configuration. This interval is specified in the
VMS.

Vipersat Migration

The Vipersat Migration command is used to set the compatibility mode for the
Hub Burst Controller when conducting a firmware upgrade on the associated
Remotes. Although this command appears in the menu for both the Hub modem
and the Remote modem, it only applies to STDMA Controllers and TDM
Outbound modems at the Hub.
Enter M at the command prompt in the Vipersat Configuration screen to
display the Vipersat Migration dialog shown in figure 3-59.
Figure 3-59
Vipersat Migration prompt
Refer to Appendix D, "Network Migration", in this document for additional
information on the use of this command.
C h ap t e r U s i n g t h e C o m m a n d L in e I n t e r f a c e ( C L I )
3 - 3-45