Wireless 802.11 General Settings - Intermec PM43 User Manual

Appendix B — Default Settings

Wireless 802.11 General Settings

116
Setting Description
(IPv6) IP Address Specifies the unique network-level
address that is assigned to each device
in a TCP/IP network (IPv6).
This section describes the 802.11 general settings. To view these
settings:
• From the printer Main Menu, select Settings > Communications
> Wireless 802.11 > General.
• From the printer web page, click the Configure tab >
Communications > Wireless 802.11.
Setting Description
Network Defines the wireless network. To
Name (SSID) communicate, all access points and wireless
devices must have the same network name,
which is case-sensitive.
Network Selects the radio behavior of the printer. Ad
Type Hoc mode allows the printer to communicate
directly with another printer. Infrastructure
mode allows the printer to communicate
through an access point.
Roaming Controls the roaming inclination of the
printer. The higher the level, the less inclined
the printer is to switch access points based on
the printer received signal strength (RSSI).
Power Mode Select the power management setting for the
radio. Constant Awake provides the highest
throughput but draws the most power. Power
Saving conserves the most power but
provides the lowest throughput. Fast Power
Saving turns off components when they are
not being used to draw less current.
Channel Sets the common channel that radios in Ad
Hoc mode use to transfer data. Range is 1 to
14.
PM43 and PM43c Mid-Range Printer User Manual
Default
Automatic
Default
INTERMEC
Infrastructure
Off
Constant
Awake
1