Intermec Fingerprint - Intermec PM43 User Manual

PM43 and PM43c Mid-Range Printer User Manual
RFID Problems and Possible Solutions (Continued)
Problem
The RFID module is installed in
the printer, but "RFID" does not
appear in the menu.
None of the RFID commands
work.
Printing on regular media (not
RFID) is slow and halted in
between labels.
I am using an application to write
to RFID tags and the printer is
printing "VOID" labels.
I receive this message "No RFID
tag found."
When I send a TAGREAD or
TAGWRITE command, I get this
error message: "Tag format
error."
Chapter 5 — Troubleshoot the Printer
Possible Solution
The printer is not communicating
properly with the RFID hardware. For
help, contact your local Intermec
representative.
RFID is disabled. Enable RFID from the
web page or the Main Menu. Go
toSettings (Main Menu) or Configure
tab (web page) > System Settings >
Manage I/O.
RFID is enabled. Disable RFID from the
web page or the Main Menu.
•
The printer may not recognize the
RFID media type. Restart the printer
or run the media or RFID calibration
wizard.
•
You may need to modify the
TAGADJUST parameter.
•
You may need to adjust the output
power (field strength) to the antenna.
•
Make sure you are using RFID media.
•
You may need to modify the
TAGADJUST parameter.
•
The tag may be broken. Try printing
on a different label.
The TAGFORMAT defined for the
operation determines the number of
required parameters. You may need to
modify the TAGFORMAT. For help, see

Intermec Fingerprint

the
Command Reference Manual
IPL Command Reference Manual
For more information, see the EPC Tag
Data Standard (v1.1, revision 1.27)
available from the EPCglobal web site at
www.epcglobalinc.org
or the
.
.
83