About Printer Languages; Select A Command Language From The Web Page - Intermec PM43 User Manual

Chapter 1 — About the Printer

About Printer Languages

Select a Command Language from the Web Page

Note: To use this procedure, the printer must be connected to your
Ethernet or wireless network.
18
The printer uses the Intermec Fingerprint printer command language
by default. You can load and run Fingerprint programs and send
Fingerprint commands or Direct Protocol print jobs directly to the
printer.
The printer supports these command languages:
• Direct Protocol (DP)
• IPL (Intermec Printer Language)
• ZSim (ZPL command language simulator)
DSim (DPL command language simulator)
•
You can change the default printer command language through the
printer web page, the Main Menu, or PrintSet.
If you are not going to use Fingerprint as the printer command
language, follow this procedure to change the command language
from the printer web page.
1 Open a web browser on your PC.
2 In the address bar, type the IP address of your printer and press
Enter. The printer web page appears.
3 Click Login. The Login page appears.
4 Type your Username and Password and then click Login. The
default value for Username is itadmin and the default value for
Password is pass.
5 Click the Configure tab.
6 Click System Settings > General.
PM43 and PM43c Mid-Range Printer User Manual