General Information - Intermec EasyCoder 201 II Installation Instructions

EasyCoder 201 II – Installation Instructions
MEMORY CARD ADAPTER KIT

General Information

EasyCoder 201 II
Memory Card Adapter Kit
Installation Instructions
Edition 3, September 1998
Part No. 1-960270-05
This leaflet contains instructions on how to install a Memory Card
Adapter in an EasyCoder 201 II or EasyCoder 201 IIE printer. (The
adapter is fitted as standard in EasyCoder 201 IISA). This optional
device could be purchased as a kit for field installation by an
authorized technician. When such is the case, please follow the
present instruction sheets for maximum safety and performance.
Before starting to modify your printer, check that the Memory Card
Adapter Kit is complete. It should include the following parts:
• 1 Memory Card Expansion Board
• 1 Memory Card Holder
• 1 Connection Cable
• 1 Address Decoder GAL 20V8
• 3 Screws
• 3 Washers
• This instruction booklet
Information in this manual is subject to change without prior notice and does
not represent a commitment on the part of Intermec Printer AB.
© Copyright Intermec PTC AB, 1998. All rights reserved. Published in Sweden.
EasyCoder is a registered trademark of Intermec Technologies Corp.
1