EasyCoder PX4i and PX6i Service Manual
Allowed interface combinations (Fingerprint)
Left-hand slot
Ports
Double Serial
uart2: + uart3:
Double Serial
uart2: + uart3:
Double Serial
uart2: + uart3:
Double Serial
uart2: + uart3:
Serial/Industrial
uart2:
Serial/Industrial
uart2:
Serial/Industrial
uart2:
Serial/Industrial
uart2:
IEEE 1284
centronics:
IEEE 1284
centronics:
IEEE 1284
centronics:
Allowed interface combinations (IPL)
Left-hand slot
Ports
IEEE 1284
parallel
Remarks:
• The left-hand slot is the slot closest to the center section.
• Always start by fi tting an interface board in the left-hand slot.
• RS-485 is only supported by "uart2:"
When fi tting driver circuit and straps before installing the interface
board, make sure that the circuit is not fi tted upside down (see front
end markings in the illustrations). Also make sure that the "legs" of the
circuit fi t into the slots in the socket and are not bent. Take ample pre-
cautions to protect the board and circuits from electrostatic discharges.
Chapter 16 — Interfaces
Right-hand slot
Ports
–
–
Double Serial
uart4: + uart5:
Serial Industrial
uart4:
IEEE 1284
centronics:
–
–
Serial/Industrial
uart3:
Double Serial
uart3: + uart4:
IEEE 1284
centronics:
–
–
Double Serial
uart2: + uart3:
Serial/Industrial
uart2:
Right-hand slot
Ports
–
–
173