Intermec EasyCoder PX4i Service Manual page 130

Chapter 11 — Paper Cutter
120
• Fit the cutter unit to the vacant hinges. Make sure that the locking plate
snaps into the groove of the right-hand hinge and that the angled plate
at the bottom of the cutter is inserted under the printer's bottom plate.
• Connect the cable from the cutter unit to the DIN socket on the print-
er's front.
DIN socket
• Tilt the cutter unit upwards until it locks into place. If the cutter does
not lock properly, the hinges of the cutter unit may need to be adjusted
using a #T10 Torx screwdriver.
• Connect the power cord and switch on power. The cutter will perform
an idle cycle in order to occupy its home position.
• Switch off the power. Tilt down the cutter and route the media through
the cutter unit between the guide plates (see illustration above). Then
tilt the cutter up again and lock it in closed position. Check that the
printhead is lowered and switch on the power. Now the printer is ready
for operation.
EasyCoder PX4i and PX6i Service Manual