The Cutting Unit's Service Position; Placing In The Service Position - Husqvarna R 422 Ts Workshop Manual

The Cutting Unit's Service Position

In order to provide good accessibility for
cleaning, repair and servicing, the unit can be
set in the service position. The service
position means that the unit is raised and
locked in the vertical position.

Placing in the Service Position

1. Position the machine on flat ground.
Apply the parking brake.
2. Set the cutting height control in the
lowest position and lift up the cutting unit.
3. Remove the front hood by removing the
pin. (There are complete instructions on
using the service position inside the front
hood).
!
WARNING!
Wear protective glasses when
dismantling the cutting unit. The spring
which tensions up the belt may break
and cause personal injury.
4. Disengage the spring for the drive belt
tensioning wheel.
76
English-
REPAIR INSTRUCTIONS