Static Routes; Ipv4 - D-Link M15-2PK Manual

Section 3 - Configuration
Go to Features > Static Routes to define custom routes to control how traf-
fic moves around your network.
To configure the Static Route IPv6 settings, click the IPv6 tab. Refer to IPv6
on page 65.
If you wish to remove a rule, click
in the Edit column. If you wish to create a new rule, click the Add
rule, click
Rule button.
If you click on Edit or Add Route, the following options will appear:
Name
Enter a name for the route.
Destination
Enter the destination IP address of the subnetwork.
Network
Mask
Enter the subnet mask of the destination address.
Gateway
Enter the IP address of the next hop, which is the gateway to the
remote network.
Metric The route metric is a value from 1 to 16 that indicates the cost (or
number of hops) of using this route. A value of 1 is the lowest cost
and 16 is the highest cost.
Interface Select the interface that the IP packet must use to transit out of the
device when this route is used.
Click Apply when you are done.
D-Link M15 User Manual

Static Routes

IPv4

in the Delete column. If you wish to edit a
64