Table of Contents
Advertisement
7 Turn the blue gear wheel forward to tension the ink
film. The ink film must not have any creases.
8 Close the device. Insert the paper tray in the opening
provided for it behind the paper feeder. Insert paper
again.
Using Service Codes
The service codes delete all the changed settings and your
device is reset to factory settings. It may be possible that the
device with the changed settings reacts differently than ex-
pected.
Using the Service Code
Only use the service code if this is absolutely neces-
sary. Many service codes also delete saved messages
and telephone book entries.
1 Press OK, 45 and OK.
2 Enter a service code:
7117—Deletes all changed settings and saved data.
The device is reset to factory settings and the initial instal-
lation process is started.
7140—Deletes all changed settings. Saved data and
telephone book entries remain intact.
7227—Deletes saved faxes, when there are prob-
lems with printing.
3 Confirm using OK.
4 Dial using [ SURE: YES .
5 Confirm using OK.
If you have entered the incorrect code, you can
cancel the entry with SURE: NO .
Resetting the device
Restart only with call-centre
Restart the device only under explicit instruc-
tions from our technical customer service (see the
back page of this user manual for the telephone num-
bers). Restarting the device deletes all personal set-
tings and the factory settings are restored.
Restart
Should the device stop reacting - for example after a
firmware update or on account of wrong settings - it is pos-
sible to restart the device. For this purpose, contact our ex-
perts from the technical customer service under any cir-
cumstances (see the back page of this user manual for
the telephone numbers). Our technicians will guide you
step-by step all through the restarting procedure.
50
Reset button
The button for restarting the device is located on the rear
side of the device. Use a pointed object (for example, a
straightened paper clip or a toothpick) to press the button.
Reset-Knopf Detail
Power Cycling
If a problem occurs that cannot be corrected with the in-
structions in this user manual (see also the help below), fol-
low the steps given here.
1 Pull out the power plug.
2 Wait at least ten seconds, then plug the power plug
back into the socket.
3 If the error occurs again, please contact our technical
customer service or your retailer. Follow the instruc-
tions on the display and on the error report.
Advertisement
Table of Contents
