Telephone Functions; Voice Over Ip; Making Telephone Calls On The Machine; Putting A Call From Cordless Telephone - Sagem IP PHONEFAX 49A User Manual

Table of Contents

Advertisement

1 Telephone func-
tions
For information on how to connect additional cordless tel-
ephones and another device and which functions are avail-
able to you, please refer the chapter on Telephone Connec-
tions and additional devices, Page 43.

Voice over IP

Default Voice over IP
Your device is preset for Voice over IP and Fax over IP.
Connect your device as described to the router of your net-
work (see section Installation help, page 4). Enter the
number of the IP connection or the fixed network connec-
tion, or select a saved entry. The connection over the In-
ternet is established.
Permanent connection
For being reachable with your Voice over IP tele-
phone number, your network should be permanently
connected with the Internet.
Telephoning via the fixed network
You can also telephone via the fixed network. Connect
your device as described to the analog telephone fixed net-
work (see section Installation help, page 4). Press **
and then dial the desired number with the numerical key-
pad, or select a saved entry.
Making Telephone Calls on the
Machine
Dial the desired telephone number. There are multiple
ways to do this. Then lift up the handset.
Dialling Directly
You can also lift up the receiver first, then dial a
number. The dialling process starts immediately.
Manual dialling: Dial the desired telephone number
with the number pad.
Loading a Short Dial Entry
You can also load short dial entries by holding the re-
spective number button pressed (for at least two sec-
onds).
Telephone book:
1 Press m
You can also load telephone book entries by
pressing OK, 11 and OK.
2 Use [ to select an entry. Enter the initial letters with
the number buttons to navigate more quickly in the tel-
ephone book.
You can save an entry multiple times with the
same name but in a different category. In the tel-
ephone book, the first letter of the category ap-
pears after the entry.
Redial list: Press @. Use [ to select an entry from the
list of dialled numbers.

Outgoing Calls

You can also load the redial list by pressing OK,
22 and OK.
14
Caller list: Hold @ pressed (for at least two seconds).
Use the [ to select an entry from the list of callers.
Calls Received
You can also load the caller list by pressing OK,
21 and OK.
CLIP Prerequisite
For this function to work, the caller line identifica-
tion (CLIP) must be activated for your telephone
connection (country and network dependent). The
number and name will not be shown if the caller sup-
presses his number.
Chain Dialling
You can combine and edit manually entered digits and
saved entries, before the dialling process starts. If you have
saved, for example, the telephone number prefix of an in-
expensive telephone service provider (call-by-call) as a tel-
ephone book entry, select this entry and manually enter
the subsequent telephone number or select another saved
entry.
Inserting a Dialling Pause
It can be necessary to insert a dialling pause into the tele-
phone number, for instance for the outside line access
code, for an extension or sub-address or in a long distance
number. Press R. The second part of the number is only
dialled once the connection with the main number has
been established.
Putting a call from cordless tele-
phone
Dialling a number
Dial the desired number. There are several ways to do this:
Then press ".
Direct dialling
You can also press " first and then dial a number.
The dialling process begins immediately.
Forwarding fax to the device
If you receive a call on the cordless telephone and
hear that it is a fax call (whistling tone or silence), you
can start the fax reception on the device. Press either
o on the device or *5 on the cordless telephone.
Manual dialling: Dial the desired number using the nu-
meric keypad.
Telephone book of the cordless telephone:
1 Long press m (at least two seconds).
2 Select an entry using [. Enter the starting letters with
the numeric keypad to quickly navigate through the tel-
ephone book.
If you have added an additional number to an en-
try, this entry appears twice in the telephone
book. The symbol of the category appears before
the name.
Telephone book of the device
1 Press m.
2 Select an entry using [. Enter the starting letters with
the numeric keypad to quickly navigate through the tel-
ephone book.

Advertisement

Table of Contents
loading

Table of Contents