Table of Contents
Advertisement
Selecting the Voice over IP provider
VoIP-provider
You must be registered with a Voice over IP provider, who
supports Session Initiation Protocol (SIP), to be able to
make telephone calls and send faxes over Internet.
1 Using [ select a provider or select manual configura-
tion.
2 Confirm using OK.
The device prints a Voice over IP installation page with in-
structions for the manual configuration of the device via
the web interface. After conclusion of the first installation,
the device registers itself automatically with the set Voice
over IP provider.
Saved providers
You can select one of the preset providers on the de-
vice and save personal details. With the web interface
you can set the device for other providers and make
further settings.
Calling the web interface briefly
You can call the web interface with an Internet browser on
a computer, which is connected to the network. Input the
private IP address of the device in the network in the ad-
dress bar of the Browser and confirm using R
as user name and password.
USER
Changing password and noting
Change the password when you call the web interface
for the first time, so that there is no unauthorised ac-
cess to your device. Note down your password in a
safe place. Should you forget your password, you
must reset your device to factory settings, in order to
be able to access it again. All personal settings will be
deleted.
IP address on network report
You will find the IP address set and other important details
regarding the device in the network report. Press OK,
87 and OK to print the network report (also see section
Voice over IP, page 29).
Entering login name
1 Enter the login name with which you login to your
Voice over IP provider.
2 Confirm using OK.
Additional user name
If you receive a user name from your provider in ad-
dition to the login name, you can enter it with the
82 function (see page 30).
Entering password
1 Enter the password which is used for login to Voice
over IP provider.
2 Confirm using OK.
The device prints an overview of the functions and then
the Voice over IP report with the necessary addresses and
status instructions.
Entering the Time and Date
Entering Time/Date
1 Enter the time, for example 14 00 for 2 o'clock
p.m.
2 Enter the date (two digits for each field), for example
08 06 07 for June 8th, 2007.
3 Confirm with OK.
Help 2 · Initial Installation Process
You can restart the initial installation process any
time. Press î and 2.
6
Inserting batteries in cordless tel-
ephone
1 Insert the new batteries in the battery compartment
with the positive and negative poles as shown in the pic-
ture in the battery compartment.
2 Place the cover on the battery compartment and slide it
. Enter
ETURN
upward until it snaps into place.
3 Place the cordless telephone into the charging station.
Putting cordless telephone in op-
eration
Switching on cordless telephone
Press the green " button for at least two seconds for
switching on your cordless telephone.
Configuring the cordless telephone
Normally your cordless telephone is registered with your
device in the factory. In the starting mode, press OK. The
display shows on which base unit and with which number
the cordless telephone is registered.
Unregistered cordless telephones
If you acquired a model with several cordless tele-
phones, only one cordless telephone is registered
with your device in the factory. Insert the batteries as
described above and register the cordless telephones
with your device (also see Chapter "Telephone con-
nections and additional devices", page 43).
Never use non-rechargeable batteries in the
cordless telephone. Follow the specifications in
the technical data.
Never place the cordless telephone into the charg-
ing station without batteries.
Leave the cordless telephone in the charging sta-
tion for at least twelve hours. The batteries will
heat up slightly during charging; this is not dan-
gerous.
Advertisement
Table of Contents
