Easylink; Service Code - Sagem Phonefax 2840 User Manual

4 Carefully remove the document either from
the front or the back.
5 Close the scanner cover on the left and right,
making sure it clicks into place.
6 Close the panel so that it also clicks into
place.
7 Insert paper (see Installation / Loading pa-
per).

Easylink

Easylink is used in conjunction with additional
devices connected to the same telephone line
(e.g. cordless phones). However, the additional
phone must be set to dual-tone multi-frequency
method. If your telephone connection requires
the pulse dialling method, then you would need
to briefl y reset your additional device to use it.
For more information about this, please see the
user manual for your device.
Starting fax reception
When you answer a call on the fax machine and
recognize that it is a fax (you hear a beep or no
sound) press START/COPY and hang up. The
fax will be received.
When you answer using an additional phone and
it turns out to be a fax, you can start the fax re-
ception by pressing *5 and then hang up. The
fax machine will receive the fax.
Interrupt ringing
When you answer on an additional phone and
the fax machine continues to ring, this means
that the additional phone is connected in parallel.
You can interrupt the ringing of the fax machine
by pressing **.
Changing codes
Select function 34 by pressing M, 34, and then
OK. Enter two different codes and confi rm each
code with OK. Each code should begin with *
or #.
Please note that the three Easylink codes must
be different. Otherwise on the display appears:
CODE not OK
v Only change the specifi ed codes *5 and
** if absolutely necessary!!

Service code

Function 45 Service code is used to delete some
or all of the settings you have changed on the fax
machine since it was supplied from the factory.
This function enables you to partially or fully
reconfi gure your device. It is especially helpful if
you have modifi ed settings but fi nd that your fax
machine does not respond as expected.
v Only use this function when absolutely
necessary!
If you are satisfi ed with your changes to the fac-
tory settings you should not use this function.
After deleting some or all of your custom settings
please rerun Easy Install.
23