Inspection; Returning The Module To Boot - Oceanic DATA PLUS Owner's Manual

INSPECTION

• Activate the unit and watch carefully as it performs a full diagnostic and
battery check and enters Surface Mode.
• Observe the LCD display to ensure it is consistently clear and sharp in
contrast throughout the screen.
• If any portions of the display are missing or appear dim, or if a Low Bat-
tery condition is indicated, return the unit to your Authorized Oceanic
Dealer for a complete inspection before attempting to use it.

RETURNING THE MODULE TO BOOT

• If the boot was fitted with a spacer and it was previously removed, re-
place the spacer into the boot.
• Orient the module over the opening in the boot, and dip the bottom edge
into it while pressing the top edge with the palm of your hand. Stop
pressing when the bottom edge of the module has just entered the boot.
• Correct the alignment of the module as needed so that it is straight.
• Press the module completely into place with your thumbs, watching the
alignment, until it snaps into place.
Care and maintenance is simple and easy, and will help keep your
Data Plus 2 in top condition for years of diving enjoyment.
Data Plus 2
67