Table of Contents
Advertisement
OM20 Universal Outdoor Modem
D.3.2 Configuring the Computer
This section is a continuation from the initial setup or can be used on an existing system that
requires a network setup change. The computer needs to be configured with the correct network
settings that were used for the Modem. Please consult with your IT manager for an IP address
mask, and modem, server, and router IP addresses valid for your network. To recognize a
subnet, each system in the subnet must have the same subnet mask. This field should be set
after the changes are made to the Modem. Refer to Figure 6.
1. Configure the computer with the new subnet addresses.
2. Initiate PING test to ensure there is communication between the modem and the
computer
Example: ping 192.168.0.238
If everything is functioning correctly, replies from the modem will appear on the computer
screen along with the time it took to respond. If unsuccessful, verify the following:
a. The cables are secured.
b. The Link Light is illuminated.
c. The IP Address that is used matches the Modem's IP Address.
d. The Server and Modem are on the same subnet.
3. Start the Internet browser on the computer and enter the new IP Address assigned by the
network administrator. Enter the new address field then press the Enter key. Reference
Figure 2
TM116 – Rev. 1.2
Figure 5. Modem Addressing Screen
Appendix D
D-
5
Advertisement
Table of Contents
