Table of Contents
Advertisement
OM20 Universal Outdoor Modem
Buffer Clock Polarity:
Number of Buffer Sources:
Active Buffer Clock:
BUFFER CLOCK SOURCES
Source 1 of 1:
Source 2:
Source 3:
Source 4:
Source 5:
RX ASYNC
Async Mode:
ES Interface:
ES Baud Rate:
ES Bits/Char:
TM116 – Rev. 1.2
{NORMAL, INVERTED}
Allows the user to select the Buffer Clock Polarity for the
Tx Terrestrial Clock relative to the Tx Data. If G.703
Interface is selected, this selection cannot be changed.
{1 – 5}
Allows the user to select up to 5 clock sources.
{RXSAT, EXTBNC, SCTE, SCT, EXT IDI}
Shows the current active buffer clock source.
{SCTE, SCE, RX SAT, EXT BNC, EXT IDI}
{SCTE, SCE, RX SAT, EXT BNC, EXT IDI}
{SCTE, SCE, RX SAT, EXT BNC, EXT IDI}
{SCTE, SCE, RX SAT, EXT BNC, EXT IDI}
{SCTE, SCE, RX SAT, EXT BNC, EXT IDI}
{ES-ES, ESC ENHANCED}
ES-ES is displayed when IBS Network Spec is selected.
ESC Enhanced can be selected in Closed Net and uses
the Overhead Signaling bytes in the IBS Overhead to
pass asynchronous data. This menu is not available
when SCC is selected.
{RS-232, RS-485}
Allows the user to select the interface type.
{150 – 1024} For IBS ES to ES
{150 – 19200} For ES to ES Enhanced
{150 – 115200} For SCC Communications
ES to ES : Fixed Baud Rate based on IBS Network
Specification. Available rates are listed in Table 3-3.
ES to ES Enhanced: Allows user to select the Interface
Baud Rate. This selection will allow the user to set rate
as listed in Table 3-3.
SCC: Allows user to select the interface Baud rate.
Interface Rate must be equal to or greater than the In-
Band Rate.
{7,8}
Allows the user to choose between 7 or 8 bit data.
Web Browser/Remote Protocol
6-41
Advertisement
Table of Contents
