Table of Contents
Advertisement
OM20 Universal Outdoor Modem
Corrected BER:
Rx Buffer Level (Fill %):
Rx Bit Errors:
+1.5V TX Supply
+1.5V RX Supply
+3.3V Supply
+5V Supply
+12V Supply
-12V Supply
+20V Supply
LNB Current (Amps):
LNB Voltage (Volts):
BUC Current (Amps):
BUC Voltage (Volts):
TM116 – Rev. 1.2
The CBER display shows an estimated corrected bit
error rate of the modem. Depending on the symbol rate
the modem is running, the high-end performance scale
of this display will vary (10 E
symbol rates, a better than scale reading will appear as
-00
0.0 x 10
. At other symbol rates, it will appear as E**. In
either case, they both mean performance is better than
the scale upper limit. This window continuously is active
and is above the Gel Tab area.
{0 – 100%}
Displays the status of the Doppler Buffer. This window is
above the Gel Tab area.
?
Displays the measured voltage of the 1.5 Volt Tx power
bus located inside the modem.
Displays the measured voltage of the 1.5 Volt Rx power
bus located inside the modem.
Displays the measured voltage of the +3.3 Volt power
bus located inside the modem.
Displays the measured voltage of the +5 Volt power bus
located inside the modem.
Displays the measured voltage of the +12 Volt power
bus located inside the modem.
Displays the measured voltage of the -12 Volt power bus
located inside the modem.
Displays the measured voltage of the +20 Volt power
bus located inside the modem.
Displays the measured current of the LNB
Displays the measured voltage of the LNB
Displays the measured current of the BUC
Displays the measured voltage of the BUCB
Web Browser/Remote Protocol
-9
-10
-11
, 10
or 10
). At some
6-45
Advertisement
Table of Contents
