Table of Contents
Advertisement
OM20 Universal Outdoor Modem
Standard OM20 Factory Default Configuration Settings
Modulator:
Data Rate:
Mode:
Satellite Framing:
Scrambler:
Drop and Insert:
Inner FEC:
Outer FEC:
Modulation:
Frequency:
Modulator Output Power:
Demodulator:
Data Rate:
Mode:
Satellite Framing:
Descrambler:
Drop and Insert:
Inner FEC:
Outer FEC:
Modulation:
Frequency:
Interface:
The default will vary depending on the interface type
Ethernet:
IP Address Mask:
Modem IP Address:
Server IP Address:
Router IP Address:
If the unit should lockup or lose communication during the initialization
process, the unit remote interface can be reset using the supplied reset
mating connector. By installing the connector on J2 and cycling power,
the unit communication parameters will be reset to the factory test
settings. Refer to section D for Quick Set-Up Guide
To lock up the modem with an internal loopback feature, enter 'IF Loopback Enable' under the
Test Menu.
TM116 – Rev. 1.2
2.048 Mbps
Closed Network
None
V.35 (IESS)
Disabled
1/2 Rate Viterbi
Disabled
QPSK
1350 MHz
-20 dBm
2.048 Mbps
Closed Network
None
V.35 (IESS)
Disabled
1/2 Rate Viterbi
Disabled
QPSK
1350 MHz
255.000.000.000
010.000.000.001
010.001.001.001
010.000.001.001
IP M&C Default Reset
OM20 Initial Configuration
3-2
Advertisement
Table of Contents
