Table of Contents
Advertisement
OM20 Universal Outdoor Modem
1. Configure the modem first with the new subnet addresses. From the modem introduction page,
click the IP ADMINISTRATION tab located on the top of the screen.
2. Enter your username and password on the logon popup, and then press the Enter key.
3. Change the Boot Mode to NON-VOL. Change IP addresses, and subnet mask to the
recommended settings and click on the Save button to accept the changes (refer to section 3.2.2
for Boot Mode descriptions).
NOTE: NON-VOL: Stores and uses IP Mask and addresses as provided by the user.
4. Click on the Cancel button at any time to abort and reload the current modem IP network
settings.
D.4.2 Configuring the Computer
This section is a continuation from the initial setup or can be used on an existing system that requires a
network setup change. The computer needs to be configured with the correct network settings that were
used for the Modem. Please consult with your IT manager for an IP address mask, and modem, server,
and router IP addresses valid for your network. To recognize a subnet, each system in the subnet must
MN-OM20– Revision 5
Figure 5. Modem Addressing Screen
Appendix D
D–5
Advertisement
Table of Contents
