Table of Contents
Advertisement
OM20 Universal Outdoor Modem
The value displayed on the top line of this menu is the 12-digit Unit ID. It is displayed as
3 sets of 4 digits in a dot-delineated format as follows:
1 2 3 4 . 1 2 3 4 . 1 2 3 4
Your Radyne Sales Representative will ask you for this number along with the features
you wish to demo.
3. Once your order has been processed, you will be issued a 12-digit demonstration code.
This code can only be used one time and it is only good on the modem for which it was
originally requested. To enter this code, perform the following:
a. From the "Enter Selection Number" line type in 45.
b. Press Enter.
c. Enter the new code and press "Enter"
d. Your system is now up graded.
If the code entered is correct, the display will display CODE ACCEPTED, otherwise the
display will read INVALID CODE
Care should be taken to insure that the demonstration code is entered
properly. After three unsuccessful attempts to enter a code, the upgrade
and demonstration capability will be locked out and it will be necessary
to cycle power on the modem in order to continue.
B.4
Canceling Demonstration Mode
At any time, a demonstration may be canceled and have the modem return to its normal
operation. Once the demonstration has been canceled, it cannot be restarted using the old
demonstration code. In order to restart a demonstration, it will be necessary to obtain a new
demonstration code.
To cancel a demonstration from the Terminal Port, perform the following:
1. From the Terminal Main Menu, type in 19 (Features) and press "Enter".
2. From the "Enter Selection Number" line type in 45.
3. Press <ENTER>.
4. Using the numeric keypad, enter 0000 0000 0000
5. Press < ENTER>.
The modem will immediately terminate the demonstration and the feature set will revert back to
the permanent configuration.
The Mod and Demod Test LED's will stop flashing.
TM116 – Rev. 1.2
Appendix B
B-
3
Advertisement
Table of Contents
