Canon imagePROGRAF iPF6300S User Manual page 857

Additionally, two modes are available in both AdjustmentPrint and Change Settings : A:High or B:Standard/Draft.
Choose the mode that suits your particular printing application.
• A:High
This setting is applied when Highest quality or High is selected in Print Quality in the printer driver.
• B:Standard/Draft
This setting is applied when Standard or Fast is selected in Print Quality in the printer driver.
Note
• Always check the Adj. Priority values before using Adjust Length. (See "Selecting a Feed Amount Ad-
justment Method (Feed Priority).")
• Use paper of the same type and size for adjustment as you will use for printing.
Paper to Prepare
When Using Rolls
When Using Sheets
Perform adjustment as follows.
1.
Load the paper.
• Loading Rolls on the Roll Holder
• Loading Rolls in the Printer
• Loading Sheets in the Feed Slot
Important
• Always make sure the loaded paper matches the type of paper specified. Adjustment cannot be com-
pleted correctly unless the loaded paper matches the settings.
2.
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab (
Note
• If the Tab Selection screen is not displayed, press the Menu button.
3.
Press the OK button.
The Set./Adj. Menu is displayed.
4.
Press ▲ or ▼ to select Adjust Printer, and then press the OK button.
5.
Press ▲ or ▼ to select Feed Priority, and then press the OK button.
iPF6300S
Adjustments for Better Print Quality
→P.833
• An unused roll at least 10 inches wide
• High-precision ruler
• One sheet of unused paper of at least A4/Letter size
• High-precision ruler
→P.781
→P.784
→P.809
> Adjusting the feed amount
).
Adjusting Line Length (Adjust Length)
>
7
839